Insta360 X5 Cooling Screen Protector

- Screen protector that effectively reduces the camera's temperature in direct sunlight.
- Made with cooling materials and strong tempered glass for greater protection.
- High-definition display and crystal clear transparency.
- Custom curved design for a precise fit with flawless coverage.

Cooling Screen Protector

Cool it down and protect your camera.

Keep your cool

Specialized temperature-control coating blocks direct sunlight and reduces the camera's temperature by up to 9ºF (5ºC)*.

*Measured in a 95ºF (35ºC) outdoor environment with the Cooling Screen Protector installed onto Insta360 X5 in 30 minutes of direct sunlight, compared to shooting without the Cooling Screen Protector. The cooling effect may vary depending on the temperature, angle of the sun, and wind speed.

Made of stronger stuff

High-strength tempered glass that's impact and scratch-resistant.

See things clearly

Provides more than 90% light transmission for the same clarity and brightness you'd expect from your X5.

Let's get aligned

Comes with an Alignment Tool and a full Protector Application Kit for easy at-home installation.

How to Use

1. Use the Screen Cleaning Wipe and Screen Cloth to clean the touchscreen, then use the Dust Removal Sticker to ensure the touchscreen is completely clear of dust and other particulate matter.
2. Clip the Alignment Tool directly to the front of X5.
3. Pinch the tab on the top corner of the Cooling Screen Protector and peel the film off. With the Insta360 logo facing upwards and at the bottom, matching the position of the Insta360 logo on the touchscreen, slowly apply the Cooling Screen Protector using the Alignment Tool as a guide. Avoid pressing down on the middle of the Cooling Screen Protector during this process as it could trap air bubbles underneath.
4. Remove the Alignment Tool and use the Scraper to eliminate any air bubbles by scraping downwards from the lens to the "Insta360" at the bottom.

Notes

1. If you already have a screen protector installed on your X5, remove it with the Film Removal Stick before installing the Cooling Screen Protector.
2. When removing air bubbles, only scrape in one direction, from the lens end down to the "Insta360", to prevent new air bubbles from forming.
3. Do not reinstall the Cooling Screen Protector once it has been removed as any collected dust or particulate matter may create air bubbles and reduce adhesiveness.
4. If the Cooling Screen Protector becomes misaligned during installation, use the Film Removal Stick and lift the corner, then repeat the above steps. Do not completely remove the Cooling Screen Protector from the touchscreen during installation.
5. The Cooling Screen Protector is recommended for outdoor recording scenarios involving strong, direct sunlight. The cooling performance will be affected by other conditions, such as the shooting environment's overall temperature and wind speed.