StarTech.com PWRSTRPCLMP Desk Mount for Power Strip - Clamp-on

the clamp has rubbery pads that squish, so if you do push against the power plug too hard it may shift backwards slightly that needs correcting which is slightly counterintuitive, but overall works as intended and can't complain the clamp has rubbery pads that squish, so if you do push against the power plug too hard it may shift backwards slightly that needs correcting which is slightly counterintuitive, but overall works as intended and can't complain

I'll start with a Buyer Beware: The power strip clamp only supports thin power boards of about a maximum width of about 6cm or 2.4inches. So factor that in when deciding on this and use it with a thin power strip or you can do a bit of DIY and make an adapter from a length of wood that will fit the clamp, and then mount your power strip to it.

The product itself is sturdily constructed and very easy to set up. Although I wouldn't call it a must have cable management item, it's a good way to quickly fasten a power board to the side of any tabletop. Or even under it if you flip it over.

The cable management route on the back of it made ...view more I'll start with a Buyer Beware: The power strip clamp only supports thin power boards of about a maximum width of about 6cm or 2.4inches. So factor that in when deciding on this and use it with a thin power strip or you can do a bit of DIY and make an adapter from a length of wood that will fit the clamp, and then mount your power strip to it.

The product itself is sturdily constructed and very easy to set up. Although I wouldn't call it a must have cable management item, it's a good way to quickly fasten a power board to the side of any tabletop. Or even under it if you flip it over.

The cable management route on the back of it made of plastic and quite sharp along the edges. Take care when handling the clamp.

works as described works as described