Antec NX500M MidTower MATX Gaming Case Tempered Glass, 3x ARGB Fan Pre-installed CPU Cooler Support Upto 155mm, GPU Support Upto 320mm, 5x PCI Slot, 360mm Radiator Supported, Front I/O: 1x Type C, 3x USB, HD Audio

I do like the look of this case here but there are a few bad things with it.
The RGB is hard to set up, the instructions are confusing.
Not much space underneath near the psu, had to remove hard drive bracket thing to actually fit the power supply in.
Get something else, maybe more expensive, would recommend if you like the look of it. There are some better cases for cheaper. I do like the look of this case here but there are a few bad things with it.
The RGB is hard to set up, the instructions are confusing.
Not much space underneath near the psu, had to remove hard drive bracket thing to actually fit the power supply in.
Get something else, maybe more expensive, would recommend if you like the look of it. There are some better cases for cheaper.

This is a low build quality case that is fine for a low cost PC due to the three included fans. There are a few things to consider:
- The daisy chain set up of RGB fans (and use of SATA power cable) makes cable management more annoying. Especially since there isn't a huge amount of space for cable management at the back anyway.
- Make sure your motherboard has a USB 3.2 gen 2 connector for the front panel, otherwise you lose three USB and the audio/microphone ports. Most cheap motherboards don't have this, and I needed to buy a USB 3.0 to 3.2 converter.
- Came with only the stand-offs for ITX motherboards installed. The remaining stand offs w...view more This is a low build quality case that is fine for a low cost PC due to the three included fans. There are a few things to consider:
- The daisy chain set up of RGB fans (and use of SATA power cable) makes cable management more annoying. Especially since there isn't a huge amount of space for cable management at the back anyway.
- Make sure your motherboard has a USB 3.2 gen 2 connector for the front panel, otherwise you lose three USB and the audio/microphone ports. Most cheap motherboards don't have this, and I needed to buy a USB 3.0 to 3.2 converter.
- Came with only the stand-offs for ITX motherboards installed. The remaining stand offs were annoying to screw in, because of the slightly small screw holes and the flex in the case. I was slightly concerned about bending it too much.
The case is not pleasant to use, but that is expected at this price point, and is overall fair value if you get it on sale.